It can be peeled off by lifting one edge with a razor blade and pulling the dry film up and off. If you think you might want to change the decoration sometime in the future, then you can leave it unsealed. Step 8 is optional, but if you want the decal to be permanent, you’ll need to put sealer over it. More aggressive products like Nitro or polyurethane can react with the ink if they melt thru the decals protective coat, to avoid this light spray (myst coats) the first 4 coats and make sure the first coat is fully dry before you apply the next. Metallic decals (Gold or Silver) are more sensitive to chemicals, water based lacquer is recommended. You must apply several 'dust coats' first and let them dry otherwise you are at risk of the decal melting. When the decal is smooth, set it aside to dry thoroughly, for at least 3 hours or more.Ĩ. After the decal is fully dry you can apply a top coat of clear varnish to seal it permanently. Neck profile: C - thickness at 1st fret: 21.08 mm (0.830') / 12th fret: 22.86 mm (0.900') Fretboard radius: 241 mm (9. Look at the reflection of light on the decal to help you spot the bubbles.ħ. Use a paper towel to gently dab off the excess moisture and work any wrinkles and bubbles out of the decal. You should be able to slide it a little to centre it properly.Ħ. Remove the decal from the backing and place it carefully onto the instrument. Fender Sub-Sonic Baritone Telecaster Neck, 22 Medium Jumbo Frets, Pau Ferro FB.

When you are ready to apply the decal, plunge it into the warm water and hold it under the surface for 30-60 seconds, until you can begin to slide the thin film off the backing paper.ĥ. It's more or less a hardtail standard Fat Strat with a 27' Scale. These are increasingly rare, especially in this condition. Use masking tape to mark the positions so you can easily place the wet decal(s) properly without guessing.Ĥ. Fender Vintage Noiseless Single Coil and DH-1 Humbucker Pickups. If you are installing two decals on the same instrument, use a ruler to make sure they are positioned symmetrically. Once the decal is cut out, plan your placement of it on the instrument. Acquista Fender Sub-sonic Baritone Stratocaster Neck, 22 Medium Jumbo Frets, Maple - 0990403921 - crafted at our ensenada, mexico, manufacturing facility. 2019 Fender American Professional body loaded with a Shawbucker wide range humbucker in the neck, and V-Mod tele bridge pickup, Fender Subsonic Telecaster neck with a nice dark Pao Ferro board, loaded with American locking tuners. Cut the decal roughly 1 to 2 mm around the edge of the image, the edge will be transparent once you slide it off the backing paper.ģ. Haven't played this much since I switched mainly to hollowbodies. Gather these materials before you start:Ģ. You may also apply the decals to a fully finished instrument (no need for sanding if the surface is clean and smooth).ġ. Price Guide Excludes Brand New, B Stock, Fair, Poor, and Non-functioning. Waterslide decals may not adhere properly on satin finish.įor best results apply the decal over bright shiny surfaces. Model Sub-Family: Fender Super Sonic 100. Prepare your wood surface by applying at least one coat of hard finish, such as varnish or lacquer. Please confirm size before completing the purchase (rulers on top and on the bottom of the decal image).

Fender subsonic